Nominated Discussion: Bring down IPsec tunnel manually (2024)

I am troubleshooting an issue where I need to bring down the IPsec tunnel manually, what is the best way to do this in GUI or CLI?

Thanks

Depending on whether you want to bounce the tunnel or actually disable it, you have different options.

The following CLI commands will tear down the VPN tunnel (phase1 & phase2 respectively):

• Phase 1
  

  > clear vpn ike-sa gateway <gw-name>​

• Phase 2
  

  > clear vpn ipsec-sa tunnel <tunnel-name>​

Follow these steps to clear (bounce) a tunnel using the GUI:

• Phase 1
  • Goto Network > IPsec tunnels and select your tunnel
  • Click IKE-Info
  • At the bottom, click the action you want (Refresh or Restart)
    
• Phase 2
  • Goto Network > IPsec tunnels and select your tunnel
  • Click Tunnel-Info
  • At the bottom, click the action you want (Refresh or Restart)
    

Instead of bouncing, you can also choose to disable/enable IKE gateways or IPsec tunnels.

• Enable/Disable an IKE Gateway
  • Go to Network

    > Network Profiles > IKE Gateways and select the gateway in question.

  • Click Enable/Disable at the bottom of the screen
    
• Enable/Disable an IPsec tunnel
  • Go to Network

    > IPSec Tunnels and select the tunnel in question

  • Click Enable/Disable at the bottom of the screen
    

For more information:

• Refresh or Restart an IKE Gateway or IPSec Tunnel
• How to check Status, Clear, Restore, and Monitor an IPSEC VPN Tunnel
• Enable or Disable an IKE Gateway or IPSec Tunnel
• How to Troubleshoot IPSec VPN connectivity issues