Command to check Tunnel Uptime (2024)

FAQs

How to check tunnel uptime in Cisco? ›

Run the “show vpn-sessiondb l2l” ” command to verify the uptime and the login time of the IPsec LAN to LAN tunnels. If the uptime is low then could be an issue like link flapping or IP sec misconfiguration.

Are these for Cisco devices? You can use 'show version' command (no quotes) from the # prompt to show uptime. For more detail on devices being up\down, take a look at using PRTG for SNMP monitoring.

To view status information about active IPsec tunnels, use the show ipsec tunnel command. This command prints status output for all IPsec tunnels, and it also supports printing tunnel information individually by providing the tunnel ID.

Connect to your cloud server on the command line. Type systeminfo and press Enter. Look for the line that starts with Statistics since , which indicates the date and time when the uptime started.

In order to monitor the tunnel status, navigate to the CLI of the FTD or ASA. From the FTD CLI, verify phase-1 and phase-2 with the command show crypto ikev2 sa. This section provides information you can use in order to troubleshoot your configuration. The most common cause of tunnel failures is a connectivity issue.

using the command ASA#show vpn-sessiondb detail l2l , shows only the active tunnels and their information.

To view current tunnel logging settings

Select the VPN connection that you want to view from the VPN connections list. Choose the Tunnel details tab. Expand the Tunnel 1 options and Tunnel 2 options sections to view all tunnel configuration details.

How to check node uptime? ›

uptime() method is an inbuilt application programming interface of the os module which is used to get system uptime in seconds. Parameters: This method does not accept any parameters. Return Value: This method returns an integer value that specifies the number of seconds the system is running i.e. system uptime.

Technical Tip: How to identify the uptime of an IPsec tunnel

FortiGate. Navigate to Dashboard -> Network -> IPsec widget -> Right-click on the available columns and add the 'created' field as shown in the above screenshot. diag vpn ike gateway list <- For all tunnels.

Enter the show version | grep up command in order to display the uptime of the security appliance. The device can be rebooted with one of these methods. For ASA security appliances: CLI – Enter the reload command in privileged mode.